Led Tape IP68

£9.31 tax incl.

Add to cart

£53.40 tax incl.

in stock

Reduced price!

LMS LED Strip Tape (12 watt per metre) IP68 fully waterproof,  powerful light source, 50,000 hrs lamp life.    Available in Blue, Warm White, Pure White and colour change. Drivers required seperately

More details

Quantity discount

Order 100 items Order 48 items Order 24 items Order 12 items Order 6 items
Save £1.49 per item Save £1.21 per item Save £0.93 per item Save £0.56 per item Save £0.28 per item

High power Single or Colour Changing Cove Light

This is an extremely thin IP68 powerful light source that comes in a 5m reel. We sell this by the metre and offer a cutting service. Select from a variety of colours Including Warm and pure white. At only 10mm wide and easy to install with the self adhesive tape this truly is a professional product ideal for Clubs, Bars, Restaurants, Hotels and more!


  • Domestic
  • Coving
  • Restaurants
  • Bars & Leisure Centres
  • Aquariums


  • No Colour fade
  • High Brightness
  • Fast & Simple installation
  • Low Maintenance
  • Long Life (50,000 hours)
  • Low power consumption (Up to 90% energy savings over Neon)


  • IP 68 Totally Waterproof
  • Cost Effective
  • Smooth Linear Effect
  • Super Bright LEDs
  • 5 Metre Reels for Ease of Installation




  • 12 volts DC – (2 core cable)
  • 12w per metre
  • 60w per 5 metre reel
  • 10mm wide x 4mm x 5 metre reel


  • White PCB flexible circuit board with SMD’s
  • Length 5 metres rolls but can be cut to smaller lenghts


  • IP 68
  • 300 leds per reel
  • Led –5050 smd
  • Colours available – Red, Blue, Green, White & Colour changing
  • Lumen Maintenance 70% @ 50,000 hours

Lumen Data

  • Warm white / pure white 360 Lm/m
  • Red 120 lm/m
  • Green 240 lm/m
  • Blue150 lm/m


  • Cut points every 50mm
  • Mounting – 3m tape- clips

Wiring and connections

  • 2 core cable – red (+) black (-)
  • You can re solder starter cable at any cut point
  • Extendable with cable at least 0.25mm
  • Do not extend more than 15 metres unless the cable is at least 1mm

Compatible power supply

  • 5m 10m 20m


Cutting and joining the LED Tape

  • You need to cut the tape along the line between the 8 copper pads, so there are 4 remaining on either side, as shown below (for single colour this is the same just 2 pads instead of 4):


  • Then solder extension wires as long as you require from each of the (+) positive (R) red, (G) green, and (B) blue pads.
  • For rejoining the led tape without extending wire cut each side of the pads in half so when pushed together this makes a whole pad and apply solder.  

3 other products in the same category:


No products

Shipping £0.00
Total £0.00

Cart Check out